Truma_service (on Raspberry pi), can´t see the fake iNet BOX unit after reset/PR set
Hi,
Would you please help how to debug the connection of Womolin LIN interface (https://womolin.de/produkt/tin-ci-lin-interface/), with TRUMA iNet ready system?
- inetbox.py successfully installed, UART enabled, serial port opened, OK
- 12V (+12V and GND) to the car 12V battery (same for TRUMA (new model 2022/23, serial 4.0***) TX(LIN interface) to RX (raspi) RX (LIN interface) to TX (raspi) 3.3V LIN to raspi GND LIN to GND raspi RJ12 all 3sockets plugged (LIN interface - TRUMA heater, TRUMA Aventa, TRUMA CP)
- MQTT works, OK
- run the program truma_service, OK
- PR Set done, but can´t see the LIN interface (fake TRUMA iNet box)
Thank you